18/11/2026

Star Wars Unlimited 3D Cards

I really like when people turn TCG cards into little 3D cards by cutting up multiple copies of that card and glue it back together. It sits in the same realm of like as when people paint over cards with their own artwork for me. Well handily I now actually engage in a TCG of my own: Star Wars Unlimited. And with the newest set they realized the Gungans as an actually playable tribe. Starting out as a joke I set my mind to making a Gungan only(with some exceptions) Deck. All that worked and it is a surprisingly good deck all things considered. What did bother me though was that while they release four acrylic bases for this set, the Naboo one came in the wrong colour. From there I kept thinking about how I should just make my own little Acrylic base using multiple copies of the base(it is easy to come by). 


With that backstory out of the way we move forward to where I decided to take the plunge. Obviously I did not want to immediately go for the actual card I wanted, since that would be quite difficult to pull off on my first try. As you can see the card in question above it is quite a beast to properly make this look 3D with all the appropriate layers.



Instead I started out with this Pack Guardian card. The process took quite a few hours to cleanly cut out the multiple cards, paint the rims black and then reattach all the pieces correctly. As you can see I somewhat rushed into things, not checking if I had enough cards to do all the layers necessary; But also my layout is somewhat silly. That is not to say I am not immensely proud of what I did, because I am.
For those curious about how I made this card, the process is as follows:
  1. Grab up to four copies of the card in question and find the layers you want to elevate.
  2. Save one card as your background, then cleanly remove the images from the other four; For a straight cut you want to use a metal ruler of some kind and a fresh scalpel. 
  3. Start slowly tracing the parts you want to turn into layers, usually the outlines will serve as a guide, but on stuff like furs you have to make judgement calls by yourself. I recommend starting from the lowest layer and work towards the top layer.
  4. Press the pieces flat with a card(I use an old bank card)
  5. grab a small brush and paint the rims of all the pieces black
  6. Start test fitting the first layers, once you ensured a nice fit start gluing layer by layer with a thin coat of super glue, always make sure to press tightly for a snug fit.

This being my first attempt I am quite ecstatic about the results. It has been a while since last I tried something wholly new like this. It actually succeeding gave me quite the rush; So of course I got greedy and immediately did it again.


Card number 2 is this Wroshyr Rebel. The card had a really nice depth to it already which lends itself to quite the easy layer layout. 
This time I made sure I had enough cards to get all the necessary parts and not panic midway through. At this point both my hand and neck started feeling really cramped though, making this card take quite a bit longer I feel(I think I finished around midnight). Being my second card this one ended up looking quite a bit nicer than the first one. There are still some mistakes though, such as the frames not being quite well aligned and there being two bumps on the right side. Despite that, the card still looks fantastic and feels really good to hold. 

My first two projects of this kind were really fun. It was a nice change of pace to try out a new artistic medium. While I doubt I am going to be doing this a lot, I might try to modify my Jar Jar Leader Card and the aforementioned Otoh Gunga Base 

No comments:

Post a Comment